top of page
Capture4.PNG

Medic Imaging Scale

Initial State of Project

​

In May 2019, I was recruited by the Medic.Life Product Manager to look into possible technological expansions of the toilet floor scale. The Product Manager wanted to see what sensors we could add to more efficiently use the available real estate. At the time, the scale was only designed to measure weight with the option to also measure Bio-Impedance (BMI, bone mass, muscle mass, heart rate, etc.) later on. Other than that, the project was very open-ended.

Goal of Work​

​

When I started the project, the only requirement was that the scale should gather more data than just weight and Bio-Impedance. The scale project was to be combined with the SuperLav product later on. At the end of the research portion of the project, I was to create a multi-faceted proposal to management as to what development path would be the most profitable. Afterwards, prototyping and data model development would be carried out.

Work Accomplished

​

This project consisted of three main work areas: research and data sensing proposal, data collection and sensor validation, and product design.

​

Research and data sensing proposal -

At the beginning of the project, I was tasked with finding data collection opportunities that could be implemented on a floor scale platform. I did this by first researching commonly occurring foot maladies as well as conditions that are expensive to correct unless treated early. I then researched what sensing methods could be used to detect these conditions. I found that most conditions are best detected by visual symptoms on the surface of the foot. This led me to recommend a three-pronged sensing approach using Near Infrared Imaging, Thermal Imaging, and Visual Imaging combined with computer vision analysis and machine learning. I presented my findings to management with a cost-benefit analysis and was given three months to pursue the project.

​

Data collection and sensor validation -

After receiving clearance to pursue the project, I began sourcing multiple camera modules and building test setups to gather data for the data analysis team so that they could start building image analysis and detection models. I created a "test mule" setup that allowed me to mount cameras wherever I wanted to on the scale platform in order to find out what positions provided the best data. 

​

Product design -

Once the sensors were validated as providing insightful data, I designed the lifting imaging scale. The lifting arms and pivoting platform had a multi-faceted purpose. They allowed the cameras in the front cross bar to capture pictures of the top/front of the foot as well as allowing a thermal camera in the back cross bar to capture images of the bottom of the foot. The cameras would then be hidden seamlessly when the scale was lowered. The scale lift motion was controlled by a large planetary gear motor in the base of the SuperLav while the scale platform angle was controlled by actuators in the arms.

IMG_20190926_191211127_BURST000_COVER_TO

Result of Work​

​

Due to my work done at Medic.Life on the Medic SuperLav and Imaging Scale, Medic.life was able to present the SuperLav to the elite upper management of a major bathroom fixture company (confidential), including the CEO and chairman of the board, as part of acquisition negotiations, as well as prepare for a professional functional demonstration at the 2020 HIMMS conference (which was unfortunately cancelled at the last minute due to the COVID-19 pandemic).

bottom of page