
Thor, King of Cast-gard
Produce a repeatable plastic key chain design that can be 3D printed, used to create a silicon mold, and cast repeatedly using resin fill. Design requirements included:
Problem Statement
-
must be less than 2 cubic inches
-
no single dimension longer than 4 inches
-
no wall thickness less than 0.06"
-
must be one continuous shape with no voids

This project was split into 3 major sections: Design modeling, design printing, and mold and cast production
Phase 1: Design Modeling
In this stage of the project, I utilized a 3D model of Thor's hammer, Mjulnir, from the popular Marvel Cinematic Universe. In planning for the 3D printing and casting of this part, I performed various geometric analyses in order to make sure the cast would go well and also to know where a parting line would be best placed for my two-sided mold. To do this, I performed a draft analysis and found that the large perpendicular sides of my model could create problems for my mold. However, since I created my mold with silicone, i knew it would be flexible enough to handle a 0 degree relief angle. I also checked to make sure the thinnest wall thickness was at least 0.06" in order to allow the resin material to fill in all voids.









Phase 2: Design Printing
After preparing the model, I then proceeded to 3D print the hammer model using a FormLabs resin printer to use as a master for creating the mold later on. After printing, I sanded down the model to get the best possible surface finish from my cast copies.




Phase 3: Mold and Cast Production
After printing and sanding my master model, I built up clay around half of my mold and then built a box around it to hold the silicone poured in to create the top half of my mold. After creating the first half, I removed the clay, flipped my model and poured silicone into the other half of the box to create the second half of my mold. In this half, I made sure to include channels for a sprue and weep holes to allow the resin material to reach all parts of my mold and allow any trapped air bubbles to escape out of the weep holes. I then put the two sides together, held together with rubber bands, and poured resin in through the sprue opening and left it for 2-4 hours to cure. At this point, I removed the cast from the mold and sanded all marks left by the sprue and weep holes.





